Measure the mission profile
Capture the load during start-up, acceleration, turns, payload handling and idle periods.
ENGINEERING BRIEF
Good requirements make better decisions.
Jetray’s corporate website describes cell selection, BMS design, prototyping and custom pack services. Use this brief to discuss the scope and feasibility of your own project.
From requirements to review
Make the important interfaces explicit.
Battery references for robotics and mobile automation. Translate movement, standby and charging into a measurable duty cycle before choosing the pack architecture.
Photograph from the Jetray corporate factory page.
Coordinate control interfaces
Confirm voltage limits, BMS signals and the system response to protection events.
Test the charging workflow
Evaluate charging opportunity, connector wear, temperature monitoring and the return-to-service criteria.
A practical project brief
What to share with the engineering team.
Electrical
Nominal system voltage, allowable input window, continuous current, peak current and peak duration.
Mechanical
Available envelope, fixing points, weight constraints, cable routing, connector and polarity.
Charging & communication
Charger model, charging opportunities, temperature sensing and required BMS or communication signals.
Project & documentation
Intended use, target markets, sample quantities, forecast volume, required test evidence and revision controls.
Project review stages
Keep the decisions and the documents together.
Use these review gates to organize a project discussion with the supplier. The agreed scope and deliverables are confirmed for the individual project.
| Stage | Information to align | Decision to record |
|---|---|---|
| Requirements brief | Route-based duty cycle, acceleration peaks and idle demand; Payload, mounting, vibration conditions and service access | The equipment needs, mandatory limits and open questions. |
| Configuration review | Document the representative mission profile, controller interface and charging workflow for the exact robotic platform. | The proposed model or design scope, interface drawing and document revision. |
| Sample evaluation | Representative equipment, operating cycle and acceptance procedure. | Results, deviations and changes needed before the next stage. |
| Order preparation | The approved configuration, quantity, packaging and required shipment documents. | The purchase specification, acceptance method and agreed commercial terms. |
A useful conversation starts with a specification
Tell us what your equipment needs.
Share the load, dimensions and intended use. Ask for a current model specification and a project review.